DIY String Lampshade

- Creative Lighting, DIY

Creating your own pendant lamp is an easy (albeit time consuming) DIY project that can spruce up any room. They’re modern yet simple and classic and can fit most decor schemes. Think about the look you want and let’s begin!

IMG_3107_Vintage_zps08ddb12e

Materials Needed:
  • Embroidery Thread or Yarn. (I used about 5 skeins of embroidery thread for my lampshade, but it could be more or less depending on your lampshade)
  • 16 Gauge Crafting Wire
  • Wire Cutters
  • Scissors
  • Lampshade
  • Water (optional).

I found this super cute lamp at a thrift store over the summer, and I’ve had this shade on it as a “temporary” fix, but I’ve never liked the way it looks on this adorable lamp. It was just an awkward size, just slightly too big, but I’ve had no luck finding one that fits better.

Before_zps63928ff2

The very first thing I did, without really thinking much about it, was I ripped off all of the plastic/fabric from the metal base. Since there were no metal supports holding the top to the bottom, I ended up with 2 seperate pieces. From there, I took embroidery thread and wrapped it around the metal part.

After_Wrapping_zpsbe953c04

This is what the top part looked like after I wrapped it in embroidery thread. You could skip this step, but since my original shade was a cream color, and my new shade would be a bright white, I didn’t want the old shade to show through.

After I finised wrapping the top part, I used the crafting wire to connect the top and bottom pieces back together again. This part was a little tricky, because the wire bends very easily so it was hard to keep the top and bottom level. It doesn’t have to be perfectly straight because you can use the string in the next step to even it out. However, you do want it pretty close because this is the easiest step to get it straight. I used 4 pieces of wire in this step. Here is what mine looked like after I connected the two pieces with wire.

After_Wire_zps1c2c09ca

A little tip: Make your shade a little longer than what you want the end product to be. It will more than likely shrink up a bit in the next step from the tension of the string. In the above picture, I hadn’t wrapped the bottom portion yet, but I did do that before the next step. Also, if your lamp shade already has supporting wires, you can skip this step.

This last step is probably the hardest, so be prepared to stretch your patience just a bit. You’ll need to take your string and wrap it around the shade with even tension to make sure you don’t make the top and bottom pieces uneven. Since my embroidery thread had lots of creases in it, I put it in water first to make it easier to work with and to get the kinks out. The only downside to this step is that the string tangles much easier. I went in a zig zag pattern because it was easier to keep the pieces level. Here is what my shade looked like after my first layer of thread.

First_Layer_zpsdda9fe0a

 

I kept adding the string in this manner until I was happy with the final look. I trimmed the loose strings, and then I was finished! I think I will add some kind of protective coating, but I haven’t decided what to use yet. Here is the final product!

IMG_3107_Vintage_zps08ddb12e

 

Source: lifewithmonsters

  • Adele Germaine

    would think that using metal hangers would work really well for the side supports as not so bendable but bends really well around the tip of a needle nose pliers to join to the frame… just a thought

  • Refurbished Ideas

    Hi Adele,

    That is a great idea. Indeed metal hangers would be a great side support. This is only 1 idea what can be done, but these days we have unlimited possibilities in creation on almost everything. Reusing something what we have or an old item, can result in our next big idea 🙂